2007 yaris fog light install

For the next step we have to cut out the red wire from relay connector. Clip the red wire close connector and pull it out:. I just use a pair of diagonal cutters to snip off pieces until it fell off. When everything is said and done it should look like this:. Cut off the slack from the harness and use a butt splice to attach the new connector. Slide the metal end into either pin1 or pin2 of the connector shown below:.

Put the cover back on the fuse box and reattach the front bumper:. OEM fit, gotta love it:. Pull down the hinged panel directly below the steering coulomb:. Remove the 2 screws that hold the panel on:. Remove the 2 screws that hold the kick plate:. With the car turned on power steering make this much easier turn the wheel to the left and remove the screw: [Picture Not Uploaded].

Pull the change cup out by pushing on the side. This will expose the fuse box:. Unscrew the shift knob:. Pull up the parking brake and lift out the center switch plate. Push out the upper left blank:. Insert the new fog light switch and set the plate aside for later:. Use a 10mm socket to remove the bolt in the cup holder in the center console:. Lifting from the back of the console, remove the center console assembly exposing the factory harnesses underneath:.

Now we must finish modifying the aftermarket harness. Cut the 2 black and 1 solid blue wire as well. Remove the electrical tape holding the end of the harness together. Once everything is pulled apart you should have black, solid blue and solid green wires left in the harness. Use a butt splice to reconnect the 2 black wires. On the switch side, pull down the harness cover to expose the internal splice of the 2 green wires. Cut the green wire closest to the black wire.

It should look something like this except the black wire should still be in the harness :. Route the harness alongside the shifter:. Run the remaining black wire to the left most wall and down to the kick panel. Using a 10mm wrench, loosen the grounding bolt and attach the black ground connector:. Attach the green wire closest to the black wire that we cut out earlier from the fog switch harness to the green wire in the factory harness:.

Share More sharing options Followers 0. Reply to this topic Start new topic. Recommended Posts. ConnYaris Posted March 8, Posted March 8, Link to comment Share on other sites More sharing options Leighcm Posted March 9, Posted March 9, Very nice post Tomatogrower Posted September 11, Posted September 11, Very nice ; thank you! Posted May 6, MMMMmmmm its dammage when i open winrar tell me its dammage : and i need it.

Posted May 14, The archive is damaged.